Optional Paper Feeders Skew can be caused by the way the media is fed through the printer. Make sure that you can push this down and it springs back into place. Removing The Controller Board Panel If the problem is still occurring, the EP setting may need adjustment.
|Date Added:||18 September 2004|
|File Size:||52.83 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
If these values are entered manually instead of through Xante accel a writer 3g then the DHCP setting on the printer must be turned off in order for the settings to apply. What can I do to correct this? FUSER writef displayed when the temperature sensor inside the fuser does not read the correct temperature too high or too low.
Xante Accel-A-Writer 3G
Removing The Controller Board Panel Calling For Technical Support Skew can be caused by the way the media is fed through the printer. My output is printing shifted left and towards the bottom of the page.
Packing The Printer Gently pull this out to ensure contact. How can I adjust the density?
Xante Accel-A-Writer 3G (free) – Download latest version in English on phpnuke
Xxante not corrected — contact Technical Support. SCANNER is displayed when the laser unit is not level, a bad connection is detected by the sensor or the scanner motor has stopped moving. Cleaning The Printer Also, make sure that xante accel a writer 3g media is aligned properly when loaded in the tray.
Turn off the printer for 30 minutes to allow fuser to cool and restart. Handling The Printer Table of contents Before You Begin Connecting To The Serial Port Make sure that they are not laying flat.
This is caused when arcing occurs across the surface of the toner drum. About This Manual Check both ends to ensure each springs back. DO NOT use media that has metal clasps, strings, staples, cutouts, perforations, or windows.
Printing Double-sided Copy Turn off the printer for 30 minutes and restart. With X-ACT, you should be able to get these line lengths within plus or minus. driter
Xante Accel-a-Writer 3G Free Driver Download (Official)
Connecting To The Parallel Port Removing A Duplexer On the right side, following the guide for the toner you will notice another contact, which is the ground. Xante accel a writer 3g the problem is still occurring, the EP setting may need adjustment. DO NOT use media that is specially coated, synthetically reinforced, colored wrirer surface treatment, or heavily textured.
Why does my IP address keep changing?
Accel-a-Writer 3G/3N/4G/4N FAQ
What protocols are supported on the printer? The problem is either a physical connection or configuration issue.
You may need to take this roller out and clean it. DHCP may not be setup to assign addresses correctly which will reassign the IP address each time you restart your printer.